Planning Application Status

PL2026075




 / 

Note: You can collapse and expand individual sections by clicking the header of the section you wish to collapse/expand.

Summary
PL2026075
John Knox Village - Meadows III North
Residential Final Development Plan
Residential Final Development Plan
In Plan Review
03/16/2026
JOHN KNOX VILLAGE
Five-Story Apartment Building including Under-Building Garage
Locations
Contacts
JOHN KNOX VILLAGE, Address:400 NW MURRAY RD  
SFCS, Inc., Address:Attn: Daron Speicht, AIA, Phone:(704) 577-6183  
BHC Engineering, Address:Attn: Eric Byrd, Phone:(913) 663-1900  
Reviews
Review Type Outcome Est. Completion Date Completed
Planning Review Corrections 03/31/2026 03/31/2026
Adair Bright
Miscellaneous Correction
Corrective Action Required
03/31/2026

Per UDO Sec. 2.360.C.29, provide a photometric diagram indicating the foot candle levels throughout the site and at the property lines.
Miscellaneous Correction
Corrective Action Required
03/31/2026

Per UDO Sec. 2.360.G, revise the site data table to include the number of dwelling units and the floor area ratio.
Miscellaneous Correction
Corrective Action Required
03/31/2026

Per UDO Sec. 2.360.D.3, dashin in the height of all roof-mounted equipment on the elevations.
Miscellaneous Correction
Corrective Action Required
03/31/2026

Confirm all ground-mounted equipment will be screened per the requirements in UDO Sec. 8.110.C.2 at the time of installation.
Engineering Review Corrections 03/31/2026 03/30/2026
Gene Williams, P.E.
Corrective Action Required
03/23/2026

A SWPPP is required for site disturbance greater than 1 acre. Provide a SWPPP if greater than 1 acre.
Corrective Action Required
03/23/2026

Sheet C5.0: (a) A valve is required just prior to the backdlow vault. Provide a gate valve. (b) water meter tap for the 2" corporation stop should be made just prior to the valve described above. (c) specify copper line from main (or in this case, the segment feeding the backflow vault) to the meter, and a minimum of ten (10) feet beyond the meter. (d) Specify the material of the line beyond the copper line (e.g., copper, etc.) and ensure it meets Code requirements.
Corrective Action Required
03/30/2026

Sheet C5.2: (a) label the storm lines as "PRIVATE" in plan and profile view.
Corrective Action Required
03/30/2026

Sheet C3.1: (a) provide slope callouts on the ADA-accessible stalls in the parking lot. (b) show an ADA-accessible route to the building from the ADA-accessible stalls. This should include cross-slope callouts and running slope callouts as necessary.
Corrective Action Required
03/30/2026

A profile view of the fire line was missing. Show any potential utility conflicts on the profile, and label the profile and plan view as "PRIVATE".
Building Codes Review No Comments 03/31/2026 03/30/2026
Joe Frogge
Fire Review Corrections 03/31/2026 03/30/2026
Jim Eden
Code Statement
Corrective Action Required
03/30/2026

All issues pertaining to life safety and property protection from the hazards of fire, explosion or dangerous conditions in new and existing buildings, structures and premises, and to the safety to fire fighters and emergency responders during emergency operations, shall be in accordance with the 2018 International Fire Code.
Fire Lanes - Marking
Corrective Action Required
03/30/2026

IFC 503.3 - Where required by the fire code official, approved signs or other approved notices or markings that include the words NO PARKING—FIRE LANE shall be provided for fire apparatus access roads to identify such roads or prohibit the obstruction thereof. The means by which fire lanes are designated shall be maintained in a clean and legible condition at all times and be replaced or repaired when necessary to provide adequate visibility. The lane along the west end of the building and the northside of the east parking area shall be posted no parking.
Dead Ends
Corrective Action Required
03/30/2026

IFC 503.2.5 - Dead-end fire apparatus access roads in excess of 150 feet (45 720 mm) in length shall be provided with an approved area for turning around fire apparatus. Provide a turn around at the east end of the parking lot.
FDC
Corrective Action Required
03/30/2026

IFC 903.3.7 - Fire department connections. The location of fire department connections shall be approved by the fire code official. Connections shall be a 4 inch Storz type fitting and located within 100 feet of a fire hydrant, or as approved by the code official. Show the location of the FDC for the building and the supply hydrant within 100 feet.
Traffic Review No Comments 03/31/2026 03/26/2026
Erin Ralovo
Fees
Paid Fees Amount Paid Owing Date Paid
Final Development Plan fee $725.00 $725.00 Paid 03/17/2026
Outstanding Fees Amount Paid Owing Date Paid
No outstanding fees.


$0.00
Hearings
Title Location Date Time
Documents & Images
Date Uploaded File Type Document Name
03/17/2026 Specifications Ext Lighting Wall Mount_Rev 0_PL2026075
03/17/2026 Application Form FDP Checklist_Rev 0_PL2026075
03/17/2026 Engineer Report/Study Flow Test_Rev 0_PL2026075
03/17/2026 Plans FDP Plan Set_Rev 0_PL2026075
03/17/2026 Engineers Estimate Private Estimate of Probable Cost_Rev 0_PL2026075
03/17/2026 Letter Storm Report Letter_Rev 0_PL2026075
03/17/2026 Letter Traffic Memo_Rev 0_PL2026075
03/17/2026 Application Form fDP Signed Application_Rev 0_PL2026075
03/17/2026 Application Form fDP Owner Signed Affidavit_Rev 0_PL2026075
03/17/2026 Receipt Receipt for transaction:2026-001602
03/31/2026 Letter Applicant Letter - FDP (DFDP)
Upload Documents

Guidelines For Electronically Submitting Documents:

  • Submitted documents should be under 100MB in size.
  • Accepted file extensions:
    • pdf, jpg, xls, doc, xlsx, docx, dwg
  • All plans shall be to scale.
  • Recommended naming conventions:
    • Keep filename consistent.
    • Avoid the use of non-friendly filenames. (ex. k9dk38fj3.pdf)
    • Avoid inappropriate language in filenames.
  • Submitted documents will be stamped at the conclusion of the review.
    • The stamp will be placed in the upper right hand corner of the document. It is recommeded that this area, to the extent possible, be left blank so that no information is lost when the the stamp is applied.
Remember to click the Upload Document button. If you are applying for a New license, make sure to click the "next step" button after you have completed the upload of documents

Select any documents you wish to provide:





Portal Home